public void SetQuality( 
   string TransferSyntax,
   object Quality
)

public:
void SetQuality( 
   String^ TransferSyntax,
   Object^ Quality
) 

'Declaration
 
Public Sub SetQuality( _
   ByVal TransferSyntax As String, _
   ByVal Quality As Object _
) 

'Usage
 
Dim instance As DicomAssociation
Dim TransferSyntax As String
Dim Quality As Object
 
instance.SetQuality(TransferSyntax, Quality)

Parameters

TransferSyntax

The transfer syntax to which this quality factor applies

Quality

The quality to be set

An application does not necessarily "know" which images will be sent by which transfer syntax, as the remote AE may have accepted different transfer syntaxes for different abstract syntaxes, and a common quality factor for an association would not therefore be appropriate. Instead, this method allows quality to be set for a specific transfer syntax.

The following limitations apply:

• This method is only meaningful when used in an application actually sending an image (normally the SCP), as there is no official means in DICOM for the SCU to send this information to the SCP.
• Where an image is already compressed using the transfer syntax required, it is not decompressed and recompressed, so this value is ignored. If absolutely necessary, this can be over-ridden by applying the DecompressAll method to the image before sending it, but multiple compressions do have an adverse effect on image quality.

At present, the only syntaxes to which this method applies are TransferSyntaxes.JPEGBaseline (1.2.840.10008.1.2.4.50), TransferSyntaxes.JPEGExtended (1.2.840.10008.1.2.4.51), TransferSyntaxes.JPEG2000Lossy (1.2.840.10008.1.2.4.90), and TransferSyntaxes.JPEG2000Lossy (1.2.840.10008.1.2.4.91), though it is also made available to private syntaxes defined through .

Target Platforms: .NET CLR 4.0 or higher